Applying Vinyl Siding Over Stucco

You will need to remove the vinyl siding before applying stucco.

Applying vinyl siding over stucco.

Vinyl siding is held in. To apply vinyl siding to a home you must first remove the exterior coatings and prepare the surface. Installing siding over existing stucco does not give us a chance to identify underlying rot issues so if you have any concerns a full removal could be your best bet. The area where the siding is being applied is wrapped with a double layer of insulating wrap before the siding is installed on the house.

The siding ends are placed directly next to the edge of the wall door frames or window frames. Install furring strips vinyl and other types of siding attach every 16 inches so you ll need vertical furring strips 16 inches apart. This would cause major problems. Vinyl siding is a decorative and protective material made up of plastic which takes the form of a wood clapboard and serves the purpose of weatherproofing along with enhancing the exterior look of a house.

Use 2 by 4 inch strips made from treated wood because stucco being a masonry product can absorb moisture and transfer it to the furring strips. Install the vinyl siding the siding begins flush with the sill plate or the bottom of the stucco wall. Over a water resistant barrier on the side of the home a paper that is infused with asphalt is applied. Lap or vinyl siding begins flush with the sill plate or at the bottom of the stucco wall.

Beyond removal to assess and repair rot damage sections of the wall where stucco is bulging or otherwise out of square may need to be removed in order to get an even fastening. Then furred chicken wire is applied over the top of that sticking out from the home a bit so that the stucco can be applied. Each new piece of siding overlaps the previous piece and is leveled to ensure a true horizontal line. Stucco has to be applied to an even surface usually over wood covered with wire mesh and roofing felt.

A few things change when installing vinyl siding over stucco however. The scratch or base layer is applied. Stucco is the type of decorative plaster that is applied usually on the exterior of a house in order to enhance its curb appeal. When installing vinyl siding you need to keep the nails out a little bit you can t send them home.

For homes with stucco exteriors a framework of wood furring strips must first be installed to create a level surface which suspends the outer layer of siding over the inner layer so that water cannot settle between the two and cause rot and erosion. The trim should hide the siding panels edges and ends but you want a little space to account for material expansion and contraction.